Perpendicular Magnetic Recording (PMR) is a recently implemented technology for data recording on hard disk.It is believed to be capable of delivering up to 10 times the storage density of older longitudinal recording, on the same recording media. PMR was of some interest in using as the storage system in floppy disks in the 1980s, but the technology was never reliable. Today there is renewed interest in using it for hard drives, which are rapidly reaching the limits of longitudinal recording. Current hard disk technology with longitudinal recording has an estimated limit of 100 to 200 gigabit per square inch due to the superparamagnetic effect, though this estimate is constantly changing. Perpendicular recording is predicted to allow information densities of up to around 1 Tbit/sq. inch (1000 Gbit/sq. inch).
The main challenge in designing magnetic information storage media is retaining the magnetization of the medium despite thermal fluctuations caused by the superparamagnetic limit. If the thermal energy is too high, there may be enough energy to reverse the magnetization in a region of the medium, destroying the data stored there. The energy required to reverse the magnetization of a magnetic region is proportional to the size of the magnetic region (where a larger magnetic region is more stable), as well as to the magnetic coercivity of the material, there is a minimum size for a magnetic region at a given temperature and coercivity. If it is any smaller it is likely to be randomly de-magnetized. Perpendicular recording uses higher coercivity material. This is possible because the head's write field penetrates the medium more efficiently in the perpendicular geometry.
The popular explanation for the advantage of perpendicular recording is that it achieves higher storage densities by aligning the poles of the magnetic elements, which represent bits, perpendicularly to the surface of the disk platter, as shown in the illustration. In this not-quite-accurate explanation, aligning the bits in this manner takes less platter than what would have been required had they been placed longitudinally. So they can be placed closer together on the platter, thus increasing the number of magnetic elements that can be stored in a given area. This is possible due to the fact that in a perpendicular arrangement the magnetic flux is guided through a magn
etically soft (and relatively thick) underlayer underneath the hard magnetic media films (considerably complicating and thickening the total disk structure). This magnetically soft underlayer can be effectively considered a part of the write head, making the write head more efficient, thus making it possible to produce a stronger write field gradient with essentially the same head materials as for longitudinal heads, and therefore allowing for the use of the higher coercivity magnetic storage medium. A higher coercivity medium is inherently thermally more stable, as stability is proportional to the product of bit (or magnetic grain) volume times the uniaxial anisotropy constant Ku, which in turn is higher for a material with a higher magnetic coercivity.
etically soft (and relatively thick) underlayer underneath the hard magnetic media films (considerably complicating and thickening the total disk structure). This magnetically soft underlayer can be effectively considered a part of the write head, making the write head more efficient, thus making it possible to produce a stronger write field gradient with essentially the same head materials as for longitudinal heads, and therefore allowing for the use of the higher coercivity magnetic storage medium. A higher coercivity medium is inherently thermally more stable, as stability is proportional to the product of bit (or magnetic grain) volume times the uniaxial anisotropy constant Ku, which in turn is higher for a material with a higher magnetic coercivity.Toshiba was the first company to make a commercially available disk drive (1.8") using this technology in 2005. The product is said to have suffered reliability setbacks in the consumer market. In January 2006, Seagate Technology began shipping its first laptop sized, 2.5 inch hard drive using perpendicular recording technology, the Seagate Momentus 5400.3. Seagate also announced at that time that the majority of its hard disk storage devices would utilize the new technology by the end of 2006. Other HDD manufacturers are also expected to adopt this technology rapidly.
No comments:
Post a Comment